ISO-01

(top left) Model ISO-01 front panel (top right) Model ISO-01 rear panel

(bottom left) Side view of ISO-01 (click on any photo to enlarge)

ISO-01 Isolation Amplifier

The EUMAC model ISO-01 single channel battery powered isolation amplifier allows for safe and efficient monitoring of voltages not referenced to ground with 1500 vrms isolation input to output and the added advantage of ground loop elimination and common mode noise rejection. The ISO-01 provides safe and efficient monitoring, measurement and recording of voltages that are not referenced to ground or common. The ISO-01 accepts voltages as low as 50 millivolts zero to peak and as high as 1000 volts zero to peak. ISO-01 output is scaled to +- 10 volts output for each switch selectable range of .05 volts to 1000 volts. The isolation amplifier's bandwidth is 91KHz and battery life is well over 24 hours on a single pair of 9-volt alkaline batteries. The ISO-01 may be powered from an optional ac supply. Typical applications include isolation and scaling of output voltage from SCR rectifier circuits. The same isolation and scaling can be done for the voltage proportional to current from current shunts. Both of these quantities are typically not referenced to ground or electronic common. Figure 1 illustrates an SCR bridge circuit powering the field winding of a turbine-generator. If one attempts to make this measurement on a four-channel oscilloscope without appropriate isolation, a serious safety hazard arises for both equipment and personnel. The circuit being measured is inadvertently grounded through the oscilloscope.

Key Benefits:

	Galvanic isolation to 1500vrm
	Decouples high power circuits from instrumentation and eliminates risk of generator/equipment tripping.
	Ensures personnel and equipment safety
	Avoids ground loops
	Scales very high or very low voltages to +- 10 volt levels

Supplied Accessories:

	One model ISO-01 instruction manual
	1500 vrms rated input leads, one red, one black, each 36 inches long
	One set alligator clips that mate to test leads

Optional Accessories:

	Model BC-1 six cell AA battery pack for extended time operation
	Various test lead adapters for connection to extremely large or extremely small conductors on devices under test (model TL-1)
	Model AC-1 extra alligator clips
	Model ACA-1 AC power adapter
	Model ISO-CC carrying case
	Additional ISO-01 instruction manuals

Warranty and Support:

One year parts and labor. Unlimited phone support on applications and troubleshooting.

Pricing:

Description	Price
ISO-01 Isolation Amplifier	$1,200.00
ISO-CC Carrying case	$120.00
BC-1 six cell battery packs (2)	$20.00
ACA-1 AC power adapters (2)	$30.00
TL-1 test leads	$30.00
AC-1 alligator clips	$25.00
Extra ISO-01 Manual	$20.00

EUMAC Inc. accepts Visa and Mastercard. Please contact us at 602-942-9168 for credit card orders. Your credit card will be billed after equipment ships.

Prices listed are in U.S. Dollars.